standard-title Sondy Prepare the IM6/Zennium for special fields of application like high impedances, low impedances, very low capacitance or boost the compliance voltage.

Sondy

Prepare the IM6/Zennium for special fields of application like high impedances, low impedances, very low capacitance or boost the compliance voltage.
FRA Probe

FRA Probe

The FRA module interfaces third-party potentiostats and electronic loads to the IM6/Zennium system. The external device must provide an analog control input and analog signal outputs for the measured current and voltage.

read more
Noise Probe

Noise Probe

The Noise Probe is a low power potentiostat for the IM6/Zennium specially designed for all common electrochemical noise techniques. In addition Zahner developed CorrElNoise®. This revolutionary new method is superior to common ECN techniques by avoiding most of their typical problems

read more
HiZ Probe

HiZ Probe

The HiZ probe set is specially designed for high impedance measurements and raise the input impedance up to 1000 TΩ || 1 pF.

read more
fF Probe

fF Probe

The femto-Farad Probe can measure very low capacitance with a resolution of 0.1 fF. Due to the transimpedance princible the fF Probe is designated for the application on two-pole objects.

read more
LoZ Cable Set

LoZ Cable Set

The LoZ cable set is specially designed for low impedance measurements. The symmetric geometry of the cables reduce the influence of mutual induction as much as possible.

read more
CVB120

CVB120

The Compliance Voltage Booster 120 provides a controlled voltage of up to ±100 V and a compliance voltage of up to ±120 V. The CVB120 is a booster which is to be connected to the Probe E/I connectors of a IM6 or Zennium.

read more